Installation Instructions I
” Powu supply oord I
Air Intake openha Exhaust vents
Before you begin operating the oven, carefully read
the following instructions.
Installing your microwave oven
1.
Empty the microwave oven and clean inside it
with a soft, damp cloth. Check for damage such
as
misaligned door, damage around the door or
dents inside the oven or on the exterior. If there
is any damage, do not operate the unit until it
has been checked by an authorized WhirlpoolSM
service technician and any repairs made.
2. Put the oven on
a
cart, counter, table or shelf
that is strong enough to hold the oven and the
food and utensils you put in
it. (The control
side of the unit Is the heavy side. Use care
when handling.)
The weight of the oven is
approximately 35 Ibs (15.75 kg).
3. Do not block the rear air intake openings or
exhaust vents. Allow
a
few inches of air
circulation at back of oven where intake
openings and exhaust vents are located.
Blocking the air intake openings and exhaust
vents can cause damage to the oven and poor
codcing results. Make sure the microwave oven
legs are in place to ensure proper
airflow.
Product Damage Hazard
Do not install the oven next to or over a heal
source (for example, a cooktop or range) or
in any area where excessive heat and steam
are generated. This could damage the
outside of the cabinet.
Built-In kit
You can build-in your oven by using one of the
following kits:
-24”for MT6900XW (Kit No. 4313646)
-27 for MT6900XW (Kit No. 4313601)
-24’ for MT6901 XW (Kit No. 4313649)
-27”
for
MT6901XW
(Kit No. 4313602)
These kits are available from your Whirlpool
Dealer. If your dealer does not stock the kit it can
be ordered by writing to:
Whirlpool
Corporation
Attention: Customer Service Dept.
1900 Whirlpool Drive
LaPorte, IN 46350
24