Replacing the light bulb
1. Unplug the power cord.
2.Remove screw on access panel.
3.Unscrew the light bulb from its socket.
4.Replace bulb with a ISwatt candelabra base bulb.
5.Replace the access panel and screw
6.Plug in the power cord.
ACCESS PANEL
Installation instructions
BEFORE YOU BEGIN, READ THE FOLLOWING INSTRUCTIONS COMPLETELY AND CAREFULLY.
Installing your microwave oven
1. Empty the microwave oven and clean inside it with a soft, damp cloth. Check for damage such as misaligned door, damage around the door or dents inside the oven or on the exterior. If there is any damage, do not operate the unit until it has been checked by an authorized Whirlpool serv- ice technician and any repair made.
2.Put the oven on a cart, counter, table or shelf that is strong enough to hold the oven and the food and utensils you put in it. (The control side 01 the unit is the heavy side. Use care when han- dling.) The weight of the oven is approximately
33 Ibs. (15.0 kg.).
SIDE
2 inches
3.Db n6t btbck the vent or alr intake open- ings on the rear of the oven. Blocking vent or air intake openings can cause damage to the oven and poor cooking results. Make sure the microwave oven legs are in place to ensure proper air flow.
4.Do not Install the microwave oven so that both sides and the top are flush with walls, shelves or cabinets. Leave clear- ance of at least 2 in. (5.08 cm] on the left side and 1 in. (2.54 cm) on the top and right side for proper operation.
Do not install the oven next to or over a
conventional surface unit or in any area where excessive heat and steam are generated. This could damage
the microwave oven.
