Audible signals
Audible signals are available to guide you when setting and using your oven. (A programming tone will sound each time you touch a pad. Two beeps will sound between cycles. A reminder tone will sound every 30 seconds after cooking is done to remind you that something has been left in the oven. A
3 second tone signals the end of the Minute Timer function.] If you don’t hear a tone, it is because of incorrectly entered instructions or because the tones have been removed. For example, a tone will not sound if you touch a Number Pad before you touch a Command Pad.
To remove the programming tone and reminder To remove ail tones, except the Minute Timer
tone:signal:
l Open the door.
l Touch CANCEL twice, then touch START.
l Programming and reminder tones will be cancelled.
l
l
l
Open the door.
Touch CANCEL twice, touch 0, then touch START.
All audible tones (except Minute Timer signal) will be cancelled.
To replace | the tones: | To replace | the tones: | |||
l Repeat | the | steps above. | l | Repeat the steps | above. | |
NOTE: it your | electricity goes off, the audible | signals | will come | back | on. Repeat steps | |
above if you want to remove them again. |
|
|
|
| ||
Setting the clock
When the oven Is first plugged in, one beep will sound and the Display shows 88:88. If the electric power ever goes off, the Display will again show all B’s when the power comes back on.
You can cook without setting the clock, but the Display will be blank after cooking.
DO THIS... | THIS HAPPENS... |
2.Touch Number Pads for the correct time of day.
3. Touch START.
The Display will show a “0”and the colon will start to flash. The tirst Number Pad must be touched within 5 seconds or the Display will go blank. Touch CLOCK SETagain and continue.
The Display will show what numbers you touched in the order you touched them. This example shows 3:25.
The colon will stop flashing. The Clock is set.
If you have touched in an incorrect time, such as 12:65, “Err”will show on the Display. Touch CLOCK SETand start over.
NOTE: To reset the clock, touch CLOCK SET.The current time and the colon will flash. Continue to set the clock as shown
will show on the Display above.
6
