Programming tone
Each time you touch a pad you will hear a tone. If you do not hear a tone,
it is because | the | instruction | is not | correct, | or | it is because | the tones | have been | ||||||
removed. |
|
|
|
|
|
|
|
|
|
|
|
|
| |
EXAMPLE: | If you | touch | a Number | Pad before | you | touch | a Command | Pad, you | ||||||
will not hear a tone. The instruction is not correct. |
|
|
|
|
| |||||||||
If you want | to remove | the | tone: |
| If you want | to | replace | the | tone: | |||||
l | Open | the | door. |
|
|
|
| l | Open | the | door. |
|
| |
l | Touch | CANCEL | twice, | then START. | l | Touch | CANCEL twice, | then | START. | |||||
l | The tone | will not sound for any |
| l | The tone | will | sound for any | correct | ||||||
| touch. |
|
|
|
|
|
|
| touch. |
|
|
|
|
|
Setting the clock
When the oven is first plugged in, the Clock/Display shows 88:88. If the electric
power ever goes off, the Clock/Display will again show all 8’s when the power comes back on.
You can cook or use the Minute Timer without setting the clock, but the display will be blank after cookrng.
DO THIS... | THIS HAPPENS... |
1. Touch CLOCK | SET. |
Touch Number Pads for the correct time of day.
Touch START.
The Display will show a “0”and the colon will start to flash. The first Number Pad must be touched within 5 seconds or the Display will go blank. Touch CLOCK SETagain and continue.
The Display will show what numbers you touched in the order you touched them. This example shows 3:25.
The colon will stop flashing. The Clock is set.
If you have touched in an incorrect time, such as12:65, “Err”will show on the Display. Touch CLOCK SETand start over.