Programming tone
Each time you touch a pad you will hear a tone. If you do not hear a tone,
it is because the instruction is not correct, or it is because the tones have been removed.
EXAMPLE: | If you touch | a Number Pad | before | you | touch | a Command | Pad, you | |||||
will not hear a tone. The instruction is not correct. |
|
|
|
|
| |||||||
If you want | to remove | the tone: | If you want | to | replace | the | tone: | |||||
l | Open | the | door. |
|
| l | Open | the | door. |
|
| |
l | Touch | CANCEL | twice, | then START | l | Touch | CANCEL twice, | then | START. | |||
l | The tone | will not | sound for any | . The tone | will | sound for any | correct | |||||
| touch. |
|
|
|
|
| touch. |
|
|
|
|
|
Setting the clock
When the oven is first plugged In, the Clock Display shows 88:88. If the electric
power ever goes off, the Clock/Display will again show all 8’s when the power comes back on.
You can cook or use the Minute Timer without setting the clock, but the display will be blank after cooking
DO THIS... | THIS HAPPENS... |
1. Touch CLOCK SET.
Touch Number Pads for the correct time of day.
The Display will show a “0”and the colon will start to flash. The first Number Pad must be touched within 5 seconds or the Display will go blank. Touch CLOCK SETagain and continue.
The Display will show what numbers you touched in the order you touched them. This example shows 3:25
Touch START.
The colon WIII stop flashing. The Clock 1sset.
If you have touched in an incorrect time, such as12:65, “Err”will show on the Display Touch CLOCK SETand start over.
