Whirlpool RBD306 Tool needed, Parts supplied, Single oven, Double oven, side view, undercounter

Single oven	Double oven
22-3/8" max.	22-3/8" max.
recessed	J
width	J

29" max. overall

height

51" max. overall height

49-1/2" recessed

height

23"max.23-3/4" recessed

_overallwidth

J

23"max.	23-3/4"
	width
recessed
depth

24" min.

cabinet

_-_

1"top ofcutout

to bottom

of

upper cabinet

door

J_

7-

•_--

24"min.

---_-

cabinet width

49-3/4"

+

min.

22-1/2"

cutout

cutout

--

height

l-1/2"min.

width

top

ofcutout

to underside

of countertop

27-3/4"

min.

cutout

height

+

14-3/4"

1-1/2" min.

bottom

bottom

of

of cutout

cutout to top

of

to floor

cabinet door

22-1/2"

cutout

width

_1

5-1/4" bottom

of

Single oven

cutout

to floor

Double oven

undercounter

(without cooktop

installed above)

24" min.

_---

cabinet width --

1" top of cutout

to bottom of

upper

cabinet

door

T

23-1/4"min.

•_--

cutoutdepth

_---

23"recessed

oven depth

27-3/4"

22-1/2"

min.

•_---

cutout

---_-

cutout

width

height

+

cabinet---+--

recessed

oven

oven

/

front

1-1/2"

32"

min.

bottom of

bottom

of

cutout

to

cutout

to

floor

top

of

cabinet

door

Single oven

Cabinet

side view

Important: Observe all governing codes and ordinances.

Proper installation isyour responsibility.

Have a qualified technician install this oven.

Oven location should be away from strong draft areas, such as windows, doors and strong heating vents.

Cabinet opening dimensions that are shown must be used. Given dimensions provide minimum clearance.

Recessedinstallation area must provide

complete enclosure around the recessed portion of the oven.

Electrical ground is required. See "Electrical requirements."

Electrical supply junction box should be located

3 inches maximum below the support surface when oven is installed in a wall cabinet. Drill a

1-inch minimum diameter hole in the right rear or left rear corner of the support surface to pass the appliance cable through to the junction box. For undercounter installation, it is recommended that the junction box be located in the adjacent right or left cabinet. If installing the junction box on rear wall behind oven, junction box must be

recessed and located in the upper or lower right or left corner of cabinet.

Oven support surface MUST be solid, level and flush with bottom of cabinet cutout.

It is the customer'sresponsibility:

To contact a qualified electrical installer. To assure that the electrical installation is adequate and in conformance with National Electrical Code, ANSI/NFPA 70 -- latest edition*, and all local codes and ordinances.

Copies of the standards listed may be obtained from:

*National Fire Protection Association Batterymarch Park

Quincy, Massachusetts 02269

Tool needed:

Z

screwdriver

Parts supplied:

4 screws (double oven)

Note: If installing a single oven, you will need only two screws and two door removal pins.

Page 1