Whirlpool RF302BXG, RF3020XG warranty Home canning information, Optional canning kit, Cookware tips

USING YOUR RANGE

USING THE COIL ELEMENTS (CONT.)

Home canning information

To protect your range:

•Use flat-bottomed canners on all types of cooktops. Canners

			with rippled or ridged
			bottoms do not allow
			good contact with the
1"		1" surface.
			• Center the canner over
			the largest coil element.
			Do not extend more than
			one inch outside the coil
Surface	Pan
			element. Large diameter
cooking area
			canners/pans, if not
centered correctly, trap heat and can cause
damage to the cooktop.

•Do not place your canner on two coil elements at the same time.

•The type of material the canner is made of determines the length of heating time. Refer to the “Characteristics of cookware materials” chart later in this section for more information.

•When canning for long periods of time, allow elements and the surrounding surfaces to cool down.

•Alternate use of the coil elements between batches or prepare small batches at a time.

•Start with hot water, cover with a lid, and bring to a boil; then reduce heat to maintain a boil or required pressure levels in a pressure canner.

•On coil element model, keep your reflector bowls clean so that they will always reflect heat well.

•For up-to-date information on canning, contact your local U.S. Government Agricultural Department Extension Office or companies who manufacture home canning products.

Optional canning kit

Most water-bath or pressure canners have large diameters. If you do canning with them at high heat settings for long periods of time, you can shorten the life of regular coil elements. This can also damage the cooktop. If you plan to use the cooktop for canning, we recommend the installation of a Canning Kit. Order the kit (Part No. 242905) from your dealer or authorized service company.

Cookware tips

•Select a pan that is about the same size as the surface cooking area. Cookware should not extend more than 1 inch (2.5 cm) outside the area.

•For best results and greater energy efficiency, use only flat-bottomed cookware that makes good contact with the surface cooking area. Cookware with rounded, warped, ribbed (such as some porcelain enamelware), or dented bottoms could cause uneven heating and poor cooking results.

•Cookware designed with slightly indented bottoms or small expansion channels can be used.

•Cookware with a non-stick finish has heating characteristics of the base material.

•Use flat bottom cookware for best heat conduction from the surface cooking area to the cookware. Determine flatness with the ruler test. Place the edge of a ruler across the bottom of the cookware. Hold it up to the light. No light should be visible under the ruler. Rotate the ruler in all directions and look for any light.

•Do not leave empty cookware, or cookware which has boiled dry, on a hot surface cooking area. The cookware could overheat, causing damage to the cookware or the surface cooking area.

8