Replacing
1.Make sure all surface units are off and cool before replacing surface units, reflector bowls and trim rings.
2. Line up openings in the reflector bowl |
| (Model RF375PXY, |
and notches in the trim ring with the | \\a | ser’ks. shown) |
surface unit receptacle and the element |
|
|
|
|
3.Hold the surface unit as level as possible with the terminal just started into the receptacle. Push the surface unit terminal into the receptacle.
4.When terminal is pushed into the receptacle as far as it wlli go, push down the edge of the surface unit oppo- site the receptacle. The element hold- down clip will keep the surface unit from moving around.
NOTE: Reflector bowls reflect heat back to the utensils on the surface units. They also help catch spills. When they are kept clean, they reflect heat better and look new longer.
If a reflector bowl or trim ring gets discol- ored, some of your utensils may not be flat enough, or some may be too large for the surface unit. In either case, some of the heat that’s meant to go into or around a utensil goes down and heats the reflector bowl or trim ring. This extra heat can discolor it.
37
