Whirlpool RF376PCY manual PROBLEM ~ Self-Cleaningcycle will not operate

,-------

PROBLEM

---.--____~

Self-Cleaning cycle will not operate

Cooking

results are not what you expected

-.-- -.-

POSSIBLE CAUSE ~--_--I

The Oven Selector and Oven

’Temperature Control Knob are not set to CLEAN.

!The range clock does not show the correct time of day.

The Lock Lever is not in the CLEAN position-all the way to the right.

!A delayed start time has been i programmed.

ihe range is not level. j

i The oven temperature is too

j low or too high.

I

----__ .~ SOLUTION

Set both the Oven Selector and Oven Temperature Control Knob to CLEAN.

Reset clock to show the correct time of day. (See page 12.)

Move Lock Lever all the way to the right.

Wait for the start time to be reached.

Level range. (See Installation Instruc- tions.)

See page 15 for instructions on how to adjust the Oven Temperature Control.

/The oven was not preheated j before baking.

The recipe has never been tested or is not from a reliable source.

The pan used is not the type or size recommended in the recipe.

There is not proper air circulation around pan when baking.

Cooking utensil does not fit the surface unit being used.

The display is There has been a power

flashingfailure. “88:88”

“F2” shows in the display

Preheat oven when called for in recipe.

Use only tested recipes from a reliable source.

Refer to a reliable cookbook for recommended pan type and size.

Allow 1% to 2 inches (4-5 cm) of air space on all sides of pan. There must be a minimum space of 1 inch

(2.5 cm).

Pan should be the same size or slightly larger than surface unit being used.

Reset the clock. (See page 12.)

Call for service. (See Step 3 on page 43.)

42