Whirlpool RF389LXK Electronic Oven Control, Display, Tones, Start, Off/Cancel, Clock, One tone

ELECTRONIC OVEN CONTROL

B		C	E
	S A

1.	Display	4.	Auto Clean	7.	Oven Settings	10.	Timed Cooking
2.	Timer	5.	Oven Light Pad	8.	Warming Drawer	11.	Hour/Minute
3.	Clock	6.	Sequence Programming		(on some models)	12.	Start/Control Lock
				9.
			(on some models)		Temperature	13.	Off/Cancel

Display

When power is first supplied to the appliance, “PF” will appear on the display. Press OFF/CANCEL to clear.

Any other time “PF” appears, a power failure has occurred. Press OFF/CANCEL and reset the Clock if needed.

When the oven is not in use, the display shows the time of day.

When using COOK TIME (on some models,) the display will show either hours and minutes, or minutes and seconds.

Tones

Tones are audible signals, indicating the following:

One tone

■Valid pad press

■Oven is preheated

■Function has been entered

Start

The START pad begins any oven function. If not pressed within 5 seconds after pressing a function pad, the “START?” indicator light will flash as a reminder. On some models, “START?” will appear on the display.

If not pressed within 4 to 5 minutes (depending on your model) after pressing a function pad, the oven display will return to the time of day mode and the programmed function will be cancelled.

Off/Cancel

The OFF/CANCEL pad stops any function except the WARMING DRAWER, Timer and Control Lock.

Clock

To Set:

Before setting, make sure the oven and Timer are off.

1.Press CLOCK.

2.Press the HR or MIN “up” or “down” arrow pads to set the time of day, including a.m. or p.m.

3.Press CLOCK or START.

Three tones

■Invalid pad press

Four tones

■End-of-cycle

■Reminder, repeating each minute after the end-of-cycle tones

Reminder Tones

Reminder tones may be turned off. Press and hold STOP TIME for 5 seconds. “rEP” will appear in the 3-digit display and “OFF” will appear in the 4-digit display. Repeat to turn reminder tones back on.

All Tones

All of the above tones are preset on, all except the end-of-cycle tones can be turned off.

To Turn Off/On: Press and hold START TIME for 5 seconds. A tone will sound and “Snd OFF” will appear on the display. Repeat to turn tones on and “Snd on” will appear on the display.

Tone Pitch (on some models)

The pitch is preset at high, but can be changed to low.

To Change: Press and hold WARMING DRAWER for 5 seconds. A tone will sound and “ Snd LO” will appear on the display. Repeat to change and “Snd Hi” will appear on display.

Fahrenheit and Celsius

The temperature is preset at Fahrenheit, but can be changed to Celsius.

To Change: Press and hold CUSTOM BROIL for 5 seconds. A tone will sound and “°C” will appear on the display. Repeat to change back to Fahrenheit. To exit mode, press OFF/CANCEL.

11