PROBLEM
=*ldno
slow drying
CHECK IF
Items are oven&fed
Fabric type and quality is suitable for dryiig
There is a large amount of moisture in the load to be dried
Cold rinse water ia used
Room air tempemture is below 45°F (7%)
Dryer is exhausted according to Installation lnstructlons
Lint screen is full
Exhaust duct or outside exhaust hood is clogged
Proper electriil supply is
Used
Load is overdried
Fabric softener is used
Synthetics, synthetic blends, permanent press and knits are in load
CAUSES/SOLUTIONS
Remove items while there is still a trace of moisture. Some itema should be removed while dsmp. then shaped and air dried.
Some knits are stretched during manufac- turing. Washing and drying returns them to the original size. This is normal. Check quality of garment before buying. Follow fabric care label directions carefully.
Some items hold more moisture than others (cottons more than polyester). They take longer to dry. Full loads take longer to dry than small loads of the same fabric.
A load rinsed in cold water will take slightly longer to dry than a warm one. Cold rinses, however, help save energy and reduce wrinkling more than warm rinses do.
Install dryer in a room where the air tempemture is warmer than 45°F (7%). Cold air increases drying time and may cause wrinkles not to be removed.
Install and exhaust your dryer according to the Installation Instructions provided.
Clean lint screen before or after each use.
Clean if needed.
Properly connect the dryer to a grounded electrical circuit that meets the electrical requirements stated in the Installation Instructions.
Remove items while there is still a trace of moisture.
Use a fabric softener and follow package directions carefully.
Synthetics, synthetic blends, permanent press and knits build up static electricity. Use a fabric softener and be careful not to overdry the load.
17
