Selecting a cycle
Use pages 7 to 0 to find information about drying cycles that may be on your model.
To Sebot I cycle:
1.Turn the Cycle Control Knob either way to a desired time or setting.
2.Stop when the indicator points to the cycle you want.
3.Push the Start Button.
ChWghgaOOfOCth:
1.TumtheCydeControfKnobtopointtoa new setting.
2.Push the Start Button, if necessary.
NOTES:
lUse the Energy Preferred Automatic
Setting (e) to dry most loads. See page 8.
lThe last few minutes of all cycles are without heat to make the load easier to
handle.
l To help reduce wrinkling, remove the load from the dryer as soon as tumbling stops. This is important for permanent press, knits, and synthetic fabrics.
lDo not overdry. Overdrying can osuse shrinkage, static ding, and damage some fabrics.
Flro Hazard
Do not dry
Failure to do so could result in fire or damaged Items.
Using the Air cycle (no heat)
The dryer does not heat when the Cycle Control Knob is set in the Air cycle. This cyde can be used to fluff or air dry bedding, plastic tablecloths, foam pillows, sneakers, etc.
1.Turn the Cycle Control Knob to the number of minutes you want in the Air cyde. (Cycle is unheated.) Refer to the chart on page 0 for suggested times.
2.Push the Start Button.
NOTE: Repeat steps above if more time is needed to dry items.
