Whirlpool RJE-3000 To remove surface unit. Ilh and pull straight out, wash surface units they

Removing surface units and reflector bowls:

1.First be sure the Surface Unit Controls are all “OFF” and that the surface units are cool.

2.Lift each surface unit about an inch (2.5 cm) at the edge away from the

plug-in		(receptacle).	Pull the	unit	straight	away	from	the plug-in.		Do
not	wash surface units; they			will	burn themselves		clean	during	normal
USe.
3. Lift	out	the reflector	bowls

To remove surface unit. Ilh and pull straight out.

Hold surface unlt level when replaclng.

Replacina reflector bowls and surface units:

Be sure the	surface		unit	controls	are	on “OFF”
;: Put the reflector		bowls		back into	their	places	Make sure	you	can see
the plug-ins	(receptacles)			for the	surface		units through	the	square

hole in the side of each bowl.

3.Hold the surface unit level with the prongs (terminals) pointing at the plug-in.

4.With the prongs started in the plug-in, start pushing in on the surface unit. At the same time. lrft a little on the side of the surface unit that’s by the plug-in.

.-5.Make sure the surface-unit prongs are pushed into the plug-in as far as they will go. The surface unit should fit into the reflector bowl and be level.

Prop up the top with support rod.

leaning under the cooktop:

To clean the area under the cooktop, lift the front of the cooktop at nter. Raise the swing-up rod to hold it. (Be sure the tip of the rod is

notch in the cooktop.) Use warm soapy water and a sponge or cloth. ring powders or any other abrasive cleaner may harm porcelain-

enamel finishes and can scratch chrome.

Be careful not to raise the cooktop so high that it touches the control console. And don’t drop it. Dropping the cooktop can chip or crack a hard porcelain finish. or damage side panels and surface units.

7