Whirlpool RJE-3000 manual Pull, straight with, of part-open, door

Foil should be flat on the bottom so should the feet on the element.

Easier cleaning with aluminum foil:

Oven cleaning can be a chore when spillovers bake onto tne

bottom of the oven. Use aluminum foil so you can just throw it away with

the spillovers. You can use the heavy-duty 18-inch (45 cm) aluminum foil

found in most grocery stores. Or you can order an aluminum foil kit (Part Number 241430) from wour WhirlDool Dealer.

When cutting the’ foil, mak;! sure it is long enough to cover the bottom with enough left over to start up both sides.

Make sure the bake element is cool. Lift it far enough to raise its feet

from the bottom of the oven. (You may have to remove the oven rack.)

Slide the foil sheet under the bake element. Make sure it is centered and long enough to start up the sides.

When you put the bake element back down. make sure all the feer

rest solidly on the foil and that the foil is smoothed ou; across the bottom of the oven. If the feet on the element are not solidly on the foil, the oven may not bake properly.

Removing

the oven

door:

Removing

the

oven

door

may

make

it

easier

to

clean

the

oven.

To

remove

the

door,

first

open

it

to

the

first stop

(about

4

inches

or

10

cm).

Take hold of both sides of the door near the top; then lift it at the same

angle

it

is

in.

Pull

straight with

the

With

the

door

off,

you

will

notice

how

the

ends

of the

hinges

slide

angle

of part-open

door.

into slots

at

the

bottom

corners

of the

door.

To

put

the

door

back on, fit

both

bottom

corners

of

the

door

over

the ends

of

the

hinges.

Push

the

door

down

evenly,

so

neither

corner

gets

ahead

of the other. When it

reaches

the

bottom,

you

can

close

the

door.

A

safety

latch

will

hold

the

door

open

until

it is on

correctly.

Push down evenly.

Swing out bottom. Lift the top.

Removing the lower panel:

To remove the lower panel, take hold of both sides at the bottom. Swing the bottom out until the panel is past the spring clips that were holding it. Now lift the panel up until the top is loose from the clips just under the oven door.

To put it back, hook the notches in the top of the panel over the clips under the oven door. Swing the bottom in until the lower spring clips snap into the notches.

8