straight out. Remember how the spring goes.
To remove surface unit, lift and pull straight out.
Cleaning and caring for your range
Your range is designed to be easy to clean. You will usually wipe off spills and spatters when they happen. but you will sometimes want to clean under and behind the control knobs and surface units. This section will tell you how to remove those. and what to use when cleaning
Removing and replacing surface unit control knobs:
1.Be sure the control knobs are set to “OFF“
2.Pull the black knobs straight off
:3 If the control has a chrome trim ring. pull It straight off
4Wash the knobs (and trim rings) in warm, sudsy water
5Replace the trim rings first. If the control spring was removed, put
it back exactly as shown on the left.. small end first.
6 Hold the black knob so it points to “OFF“Push it straight back on
Removing and replacing oven control knobs:
1Be sure the knobs are set to “OFF“
2 Pull each knob straight off.
3 Wash the knobs in warm. sudsy water.
4 The knobs are not interchangeable. Make sure you put the adjust-
able Oven Temperature Control Knob on the right place. and the
nonadjustable Oven Selector Knob on the other
Removing surface units and reflector bowls:
1First, be sure the Surface Unit Controls are all “OFF” and that the surface units are cool.
2ILIft each surface unit about an inch (2 5 cm) at the edge away from the
13 Lift out the reflector bowls.
12
