Whirlpool RJE-963PP, RJE-960P manual Removing surface units and reflector bowls

I ,\ Terminal

To remove surface unit, lift and pull straight out.

Hold surface unit level when replacing.

Push /

wte a Lift

Removing surface units and reflector bowls:

1First. be sure the Surface Unit Controls are all “OFF” and that the surface units are cool.

2See where the surface units plug into the range? Lift each surface unit about an Inch (2 5 cm) at the edge away from the plug-in (receptacle). Pull the unit strarght away from the plug-in. Do not wash surface units; they will burn themselves clean during nor- mal use.

3L.ift out the reflector bowls

Replacing reflector bowls and surface units:

1 Be sure the surface unit controls are on “OFF.”

2Put the reflector bowls back into their places Make sure you can see !he plug-ins (receptacles) for the surface units through the square hole in the side of each bowl and trim rings.

3Hold the surface unit level with the prongs (terminals) pointing at the plug-in.

4With the prongs started in the plug-in start pushing In on the surface unit At the same time. lift a little on the side of the surface unit that‘s by the plug-in

5Make sure the surface-unit prongs are pushed into the plug-in as far as they will go. The surface unit ~111fit Into the reflector bowl and be level when everythrng has been done nght.

Removing and replacing upper oven rack guides:

L.ift the front of the rack gutde. Swing it away from the oven wall fclr enough for the tab to get clear of the slot in the oven wall. Pull the gr~!dt~stralyht out of the oven To put it back. fit the end of the rack guide 111tothcl tivo holes In the back wall of the oven. Line up the tab on the gu~cltawlttl t!re slot in the side small.Push it in and push down a little to lock it ill place

15