Whirlpool RJE302B warranty Receutacie, Hold, surface unit level, when, replacing

Removing surface units and reflector bowls:

	1. First. be sure the Surface Untt Controls are all “OFF” and that the
Receutacie	surface	units are cool.
	2. Lift each surface unit about an inch (2.5 cm) at the edge away frown the
	plug-in	(receptacle).	Pull the unit straight away from the plug-irl. Do
	not wash surjace units: they will burn themselves clean during normal
	use.
	3. Lift out	the re!lector	bowls,

To remove surface unit, lift and pull straight out.

Replacins reflector bowls and surface units:

1.Be s&e the surface unit controls are on “OFF.”

Hold	surface unit level	2. Put the reflector bowls back into their places. Make sure you can see
		the plug-ins (receptacles)	for the surface units through the square
when	replacing.
		hole in the side of each bowl.

3.Hold the surface unit level with the prongs (termlnals) pointing at the plug-in

4.With the prongs started in the plug-in. start pushing in on the surface unit. At the same time. lift a little on the side of the surface unit that’s by the plug-in

5.Make sure the surface-unit prongs are pushed Into the plug-In as far as they will go The surface unit should fit into the reflector bowl and be level