louch
Cycle 1
q q q
Touch Number Pads In Order
Display Shows Selected lime
Touch
Cook
Power
(Cooking in One Cycle at a Selected Cook Power...continued)
1.Put Food In The Microwave Oven and Shut the Door.
2.Touch COOKING CYCLE 1. The Cycle 1 INGICATOR will glow and 4
zeros WIII show on the DISPLAY This tells You that the microwave oven ISready for Your next Instruction
3.Touch in the Cooking Time. The example shows what You would do
to touch In
4.Touch the COOK POWER Pad. When You touch the COOK POWER
pad, the time that showed on the DISPLAY will be replaced by 2 zeros.
Display Shows Cook Power Can Be Set
Display Shows 50%
Cooking Power
q louch 8 .
Start
5.Touch in the Cooking Power. The number You touch will tell the
microwave oven how much of full power you want. Example: If you
touch a 5. cooking will be at 50% of full power; touch a 7. cooking will
be at 70% of full power. The display will show which cook power You selected.
6.Touch START Command Pad. The Start INDICATOR will glow to let You know that the mrcrowave oven has started cookrng. After about 5 seconds it WIII go out, but the Cycle 1 and Cook Power INDICATORS will stay on during the entire cycle
While cooking, the DISPLAY will count down the seconds so You will
know how much time is left. For 2 seconds of every 10 seconds, the
DISPLAY changes to show the cook power instead of cooking time.
When the cycle is over, a buzzer will sound four times. Opening the
door or touching the CANCEL Pad turns off the buzzer. The time of day will again show on the DISPLAY.
Cooking in More Than One Cycle at Different Cook Power levels
Some foods are best when cooked part way at one power level, and finished at another. You might want a DEFROST cycle, a few minutes on high power [Cycle 11, a few more minutes on low (Cycle 2) and a few final minutes on medium (Cycle 3).
The following example shows how to touch in the instructions when You want the food to cook for 1:‘2 minutes at 50% power, then for 2 mrnutes at 40% power, and finally for 1% minutes at 50% power again.
A buzzer will sound at the end of each cycle, in case You want to check the food. The oven will not cook while you have the door open.
If you don’t open the door, the oven will continue on Cycle 2. Unless
you want to change instructions, just touch the START pad after you close the door.
