Whirlpool RS25AMXV, RS22AMXV warranty Using and maintaining special model features, Model RS22AM

Using and maintaining special model features. Model RS22AM

Changing the light bulbs.

Electrical Shock Hazard Unplug the refrigerator or disconnect the main electric power supply to the refrigerator. Failure to do so can result in electrical shock or injury.

To change refrigerator light bulb:

1.Remove the light bulb from the socket located behind the control console.

2.Replace with a 40-watt, tubular appliance bulb.

To change light bulb above crisper or freezer light bulb:

Automatic	Model and
ice maker
	serial number
R‘eezercontrol	label
Remm-;go;	utility
Ice bin	compartment
	Light
POwer-Saver
control	Adjustable
Freezer
	glass	shelves
light
Adjustable	Crisper
freezer
	light
shelves
	Statfonary
Crisper	door	she1ves
Freezer	Meat	drawer
storage	air control
trivet
	Meat
Base grille
	drawer

Leveling rollers

1.Grasp front of light shield.

2.Pull bottom of shield forward until it snaps free.

3.Remove bulb from socket.

4.Replace with a 40-watt, tubular appliance bulb.

5.Place shield over bulb and snap back into place.

Removing freezer trivet.

For proper air movement, keep freezer trivet in place when the refrigerator is operating.

To remove the trivet:

1.Lift trivet up.

2.Pull trivet forward.

To replace the trivet:

1.Slide trivet into refrigerator.

2.Lower trivet into place.

Page 6

Automatic ice maker.

(Models RS22AM and RS25AW).

1.Connect the ice maker to the water supply before turning it on.

2.The ON/OFF lever is a wire signal arm.

-Lower signal arm to make ice.

-Raise signal arm to turn off the ice maker.

Automatic ice maker tips.

. Freezer must be cold enough for the ice maker to work. This may take eight hours or more before the right temperature is reached.

. “First”ice may be discolored or off-flavored because of new plumbing connections. Throw away first few batches of ice.

. Change ice cube size with the dial or lever on the side of the ice maker.

. Ice crescents are normally attached at the comer. They break apart easily.

. Normal sounds include water running

when the ice maker is working and the thud of ice as it falls into the bin.

. If ice is not being made fast enough and more ice is needed, turn the Refrigerator Control to a higher number. Wait 24 hours, and if this does not increase the ice supply, turn the Freezer Control to C.

nRaise the signal arm before you remove the ice bin. When you return the bin, push it all the way in and lower the arm to the ON position.

nCubes left in the bin for long periods of time may develop an off-flavor, like stale water. Throw old cubes away. Cubes may also become smaller if stored for a long time.

. Good water quality is important for good ice quality. It is not recommended that you connect the ice maker to a softened water supply. If a softened water supply cannot be avoided, it is important to maintain the water softener so it operates properly. Water softener chemicals, such as salt from a malfunctioning softener, can damage the ice maker mold and lead to poor quality ice.