3.Hold the surface unit as level as possible with the terminal just started into the receptacle. Push the surface unit terminal into the receptacle.
4.When terminal is pushed into the receptacle as far as it will go, push down the edge of the surface unit opposite the receptacle. The element
NOTE: Reflector bowls reflect heat back to the utensils on the surface units. They also help catch spills. When they are kept clean, they reflect heat better and look new longer.
If a reflector bowl gets discolored, some of your utensils may not be fiat enough, or some may be too large for the surface unit. In either case, some of the heat that’s meant to go into or around a utensil goes down and heats the reflector bowl. This extra heat can discolor it.
Removing the oven door
Removing the oven door will help make it easier to clean the oven.
Burn and Electrical Shock Hazard
Make sure all controls are OFF and the oven is cool before removing oven door.
Failure to do so can resutt in burns or electrical shock.
1.Open the door to the first stop position.
2.Hold the door at both sides and lift it at the same angle it is in.
3.To replace, tit the bottom corners of the door over the ends of the hinges.
Push the door down evenly. The door will close only when it is on the hinges correctly.
20
