5.If ports are clogged, clean with a straight pin. Do not enlarge or distort port. Do not use a wooden toothpick. If adjustment is needed, call a qualified technician for service.
6.After cleaning the gas tube opening and ports, replace the trim ring and burner cap. (Trim ring must be replaced over burner base before replacing burner cap. Do not operate burners without trim rings in place.)
To replace burner cap, make sure tabs
under cap are properly aligned and leveled. Place cap on burner base with tabs fitting in slots on either side of gas tube opening (see illustration on page 11).
7.Turn on the burner to determine if it will light. If the burner does not light after cleaning, contact an authorized Whirlpoole service technician. Do not service the sealed burner yourself.
Cleaning chart
Use the following table to help you clean all parts of your cooktop.
PART | WHAT TO USE |
Control knobs Sponge and warm, soapy water
Control panel | Sponge and warm, | |
and trim | soapy | water |
| OR |
|
| Paper | towel and spray |
| glass | cleaner |
Tempered glass Sponge and warm, cooktop surface soapy water or paper
(other than towel and spray glass
control panel) cleaner
Surface burners, grates, caps, trim rings, and contoured well area
HOW TO CLEAN
l Turn knobs to OFF and pull straight away from control panel.
l Wash, rinse and dry thoroughly. Do not soak.
l Do not use steel wool or abrasive cleans- ers. They may damage the finish of the knobs.
l Replace knobs. Make sure all knobs point to OFF.
l Wash, rinse and dry thoroughly.
l Be sure to wring excess water from sponge before wiping around controls. Excess water in or around controls may cause damage to the cc&top.
lDo not use steel wool or abrasive cleansers. They may damage the finish.
l Do not spray cleaner directly on panel. Apply cleaner to paper towel.
l Wipe off regularly when cooktop is cool.
l If soap or detergent solutions are used, rinse thoroughly to prevent filmy residue.
lDry with a soft cloth.
See pages
12
