Whirlpool SF3004SR manual The Oven Vent, Lighting Standing Pilots, To light Cooktop Pilots

Models: SF3004SR

1 16
Download 16 pages 24.32 Kb
Page 9
Image 9
The Oven Vent

The Oven Vent

Hot air and moisture escape from the oven through a vent located under the backguard. Do not block vent. Poor baking will result.

OVEN VENT

Lighting Standing Pilots

To light Cooktop Pilots:

1.Remove the surface burner grates from the cooktop. Lift the cooktop and rest on support rod.

2.Make sure all controls are OFF.

To light Oven Burner Pilot:

1.Make sure the oven control is OFF

2.Remove the broiler drawer, Slide drawer out to stops, lift both sides, then slide the rest of the way out.

3.To light, hold a lit match over the pilot light located between the front and back burners. The pilot flame should be Y, to J/e in (.6X-.953 cm) high.

4.If the pilot flame needs adjust- ment, turn the pilot adjustment screw on the manifold pipe.

5.Lower the cooktop and replace the grates before using the sur- face burners.

3.Hold a lit match over the oven burner pilot located at the rear of the burner.

4.After the’oven burner pilot is burn- ing steady, check burner lighting by turning the Oven Control to a temperature above140”F (60°C). The burner will take 50-60 seconds to light.

5.Replace the broiler drawer.

9

Page 9
Image 9
Whirlpool SF3004SR manual The Oven Vent, Lighting Standing Pilots, To light Cooktop Pilots, To light Oven Burner Pilot