Whirlpool SF306PEG SETTING THE CLOCK MODEL SF3O6PEG, Display/clock, Using Your Range, Press

Models: SF303PEG SF306PEG SF302BEG SF3020EG

1 28
Download 28 pages 32.36 Kb
Page 10
Image 10
THE ELECTRONIC TIME-OF-DAY (TOD) CLOCK/TIMER

USING YOUR RANGE

THE ELECTRONIC TIME-OF-DAY (TOD) CLOCK/TIMER

(MODEL SF3O6PEG)

Electronic display

Clock pad (p. 10)

CLOCK

TIMERTIMER

Oven timer pad

(p. 11)

Increase pad

(p. 10, 11)

(MODEL SF3O6PEG)Display/clockDecrease pad

(p. 10, 11)

Display/clock

When you first plug in the range, the entire display appears followed by a flashing time-of- day. If, after you set the clock (see “Setting the clock” section), the display flashes, your electric- ity was off for a while. Reset the clock.

When you are not using the oven, the display shows the time of day.

When showing the time of day, the display will show the hour and minutes.

When you are using the timer, the display will show seconds for time less than 1 minute, minutes for time less than 1 hour, and hours and minutes for time over 1 hour. The timer indicator will be lit when in the timer mode.

SETTING THE CLOCK (MODEL SF3O6PEG)

1. Press CLOCK. The colon flashes during

PRESSYOU SEE

clock programming.

 

 

2. Set the time.

PRESS

YOU SEE

Press the “up” (▲) or “down” (▼) pad(s) until

 

 

the correct time shows on the display.

 

 

NOTE: Press a pad briefly to change time by a

 

 

small amount. Press and hold a pad to change

 

 

time by 10 minute increments.

 

 

3. Press CLOCK again to start the clock. The colon PRESS

YOU SEE

stops flashing when the clock is active.

 

10

Page 10
Image 10
Whirlpool SF306PEG SETTING THE CLOCK MODEL SF3O6PEG, Display/clock, The Electronic Time-Of-Day Tod Clock/Timer, Press