Product Damage
The ignitor must remain in its shield when removing bar broil burner.
Failure to do so could break ignitor.
Fn After the burners have been converted to Natural gas usage, complete Steps
Adjusting for proper flame
D H Replace storaae drawer, oven bottom, oven racks acd oven door. Reinstall maintop and burner grates, burner caps and burner bases. See Panel D, Step 22.
If range does not
operate...
l Check that the circuit breaker is not tripped or the house fuse blown.
l Check that power supply cord is plugged into wall receptacle.
l Check that the gas supply is turned on.
NOTE:
Plug power supply cord into outlet.
Make sure that rear leveling leg(s) are engaged in
If you need
assistance...
The Whirlpool Consumer Assistance Center will answer any questions about operating or maintaining your range not covered in the Installation Instructions. The Whirlpool Consumer Assistance Center is open 24 hours a day, 7 days a week. Just dial
Refer to Use and Care Guide for operating instructions and cleaning instructions.
When you call, you will need the range model number and serial number. Both
Product Damage
lElectric ignitors are used to light the oven and broil burners. Do Not insert any object into the openings of the shield surrounding the ignitor coil.
lDo Not clean this area.
Failure to follow these instructions could result in product damage.
A w Cooktop burners: Adjust the air shutters for proper flame by sliding the air shutter to close or open the shutter as needed. See Panel D, Steps
B w Oven burner: Loosen screw and adjust the air shutter as needed. Tighten screw. See Panel D, Steps
C n Broil burner:
1, Remove the two screws fastening the front of broil burner to oven. Pull the broil burner forward. Loosen the lock screw on the air shutter located at the rear of the broil burner.
2.Adjust air shutter as needed. The flame should be l/2” long with inner cone of bluish- green and outer mantle of dark blue. The flame also should be clean and soft in character with no blowing or lifting of flame, Tighten the lock screw. See Panel D, Steps
Personal Injury/Product Damage Hazard
Do Not step, lean or sit on the range drawer or door.
Failure to follow these instructions could result in personal injury and/or product damage.
For cleaning and
mahtenance...
If removing the range is necessary for
cleaning and maintenance, remove storage drawer. Shut off gas supply to range. Disconnect gas and electrical supply.
If gas or electrical supply is inaccessible, lift range slightly at front and pull range away from wall. Pull range out only as far as necessary to disconnect gas and electrical lines.
Remove range to complete cleaning or maintenance.
Move range back into operating position. Level range. Connect gas line to range and check for leaks. Replace storage drawer.
wid1 01 C3FCRWKt.
numbers can be found on the serial/rating plate located under the maintop.
If you need
servfce...
In the event that your Whirlpool appliance should need service, call the dealer from whom you purchased the appliance or a
-Household - Major - Service and Repair.”
You can also obtain the service company’s name and telephone number by dialing, free, within the continental United States, the Whirlpool Consumer Assistance Center telephone number,
Maintain the quality built into your Whirlpool appliance - call a
Printed on recycled paper. 10% post consumer waste/ 50% recovered materials.
Part No. | Prepared by Whirlpool Corporation, | Benton Harbor, Michigan 49022 |
0 1994 Whirlpool Corporation |
Printed in U.S.A.