| Operating Instructions |
| Adjusting Rinse Aid Dosing |
3 | As the dishes are washed rinse aid is released from the dispenser into |
| the wash water. The dose is factory set at 4, and can be adjusted from |
1 to 6. Only change the setting if streaks, milky spots or dried on water marks are visible on glasses or crockery.
0 1. Open the door of the dishwasher.
2.Press the rinse aid compartment release button with your finger.
3. Fully open the rinse aid compartment lid.
4. Set the dose level.
5. Close the lid and press until it locks into place.
6.If rinse aid has run out, wipe up with a cloth.
Setting the Signal Tone for the End of the Wash Pro- gramme
You can set whether, in addition to the optical indication of the end of the programme, a signal tone is also to be heard.
0 1. The dishwasher must be switched off.
2.Press the signal tone and water softener buttons simultaneously and keep them pressed.
3.Press the ON/OFF switch. The LED indicators for the signal tone and water softener buttons flash.
4.Press the signal tone button again.
The
b0 | Signal tone switched off |
b1 | Signal tone switched on (factory setting) |
|
|
5.Pressing the signal tone button changes the setting.
6.Once the
15
