Operating Instructions
Starting the Wash Programme
0 1. Check that the dishes and cutlery are loaded into the dishwasher in such a manner that the spray arms are free to rotate.
2.Open the tap fully.
3.Shut the door.
4.Press the ON/OFF switch (AAN/UIT; MARCHE/ARRET) The ON/OFF switch indicator (AAN/UIT; MARCHE/ARRET) illuminates.
5.Press the button for the programme required (see “Programme Table“). The programme indicator and the associated wash programme steps in the programme progress display illuminate. After around 6 seconds, the wash programme selected starts. The remaining time for the pro- gramme calculated from quantity of dishes loaded is displayed in the
3 | If fault messages are displayed on the |
| the programme, please read the “What to do, if...“ section. |
| Changing/Interrupting/Cancelling the Wash Pro- |
| gramme |
3 | Only change or interrupt a wash programme in progress if it is abso- |
| lutely necessary. When the appliance is closed again, the air that has |
| entered is heated rapidly and expands. This can cause water to escape |
| onto the floor and possibly trigger the |
| Changing the wash programme |
3 | If you want to change the wash programme within the first 6 seconds |
| after the selection of the programme, briefly press the button for the |
| required programme. |
| If you want to change the wash programme at a later point in time, use |
| the following procedure: |
0 1. Press the button for the new wash programme and keep it pressed. The indicators for both wash programmes now flash.
2.After a few seconds, only the display for the new wash programme flashes. Release the programme button, from now on the new wash programme is carried out.
26