Whirlpool TGR51 warranty Adjusting the oven temperature control, Broiling, Drain slot

Models: TGR51

1 28
Download 28 pages 2.18 Kb
Page 13
Image 13
Adjusting the oven temperature control

Adjusting the oven temperature control

Oven temperature controls will gradually shift after years of use. So, even though your new oven is properly adjusted to provide accurate temperatures, it may cook faster or slower than your old oven.

If, after using the oven for a period of time, you are not satisfied with the temperature settings, you can adjust them by following these steps:

1.Push in and turn the Oven Temperature Control Knob to the off position. Pull knob straight off and flip it over.

2. Loosen the locking screws inside the control

Locking

knob. Note the position of the notches.

 

3.To lower the temperature, hold knob handle firmly and move the tooth a notch clockwise. Each notch equals about 10°F (5°C).

4.To raise the temperature, hold knob handle firmly and move the tooth a notch counter- clockwise. Each notch equals about 10°F

(5°C).

Tighten the locking screws and replace the control knob.

Broiling

The broiler drawer is located below the oven door. Always broil with the oven door closed.

1.Pull the broiler drawer open and tilt the door panel down.

2. Place broiler

pan

grid so grease

can

drain

Drain slot

Rib

Front

down ribbing

and

through slots

into

lower

part

 

 

of the broiler pan. See picture.

 

 

 

 

 

3.Before the broiler is turned on, place food on broiler pan and positlon the broiler pan at

one of the three levels. Refer to a reliable

Side view

cookbook for broiling chart.

13

Page 13
Image 13
Whirlpool TGR51 Adjusting the oven temperature control, Broiling, knob. Note the position of the notches, Drain slot