Whirlpool TUD8700SQ Connect drain hose, Slide clamp onto connector, Hose clamp final position

Connect to Drain

1 Connect drain hose

Green clamp

Black drain hose	Drain hose
connector
	Drain hose stop
	Stop
	Stop

Place towel under drain hose to catch any water in drain hose. Place the small green drain hose clamp onto the small end of the drain hose. Push the new drain hose into the black drain hose connector up to the drain hose stop.

2 Slide clamp onto connector

Green clamp

Black drain hose

connector

Drain hose

Drain hose stop

Stop

Stop

Using pliers, squeeze open the small green drain hose clamp and slide onto connector between stops.

3 Hose clamp final position

Make Direct Wire Electrical

Connection

NOTE: If the power supply cord was connected earlier proceed to Secure Dishwasher in Cabinet Opening section.

Option B, Direct Wire:

1 Direct Wire—Route cable into terminal box

Route cable so that it does not touch dishwasher motor or lower part of dishwasher tub. Pull cable through cable clamp in terminal box.

Select UL listed or CSA approved twist-on wire connectors (not included) rated to connect your household wiring to 16-gauge dishwasher wiring.

Black drain hose connector

Drain hose

Green clamp

Drain hose stop

Stop

Stop

Once connected, remove towel.

If needed, see website for animated representation of this step. Visit www.whirlpool.com/drain under FAQ tab.

16