RANGE HOOD USE
The range hood is designed to remove smoke, cooking vapors and odors from the cooktop area. For best results, start the hood before cooking and allow it to operate several minutes after the cooking is complete to clear all smoke and odors from the kitchen.
The hood controls are located on the top of the range hood.
A
BC
A.Incandescent light housing and cover
B.Filter retainer
C.Grease filter
Range Hood Controls
Off
On | Off | Low | High |
AB
A. On/Off light switch
B. Fan speed switch
Operating the light
Push the light switch to the right to turn the light Off. Push the light switch to the left to the turn the light On.
Operating the fan
Push the fan switch to the left for Low speed. Push the fan switch to the right for High speed. Push the fan switch to the middle for Off.
To avoid damage to the stainless steel, do not use cleaners that contain chlorine.
Cleaning Method:
■Rub in direction of grain to avoid scratching or damaging the surface.
■For stainless steal models, Stainless Steel Cleaner and Polish Part Number 31462A (not included): See “Assistance or Service” section to order.
■Liquid detergent or
Rinse with clean water and dry with soft,
■Glass cleaner to remove fingerprints.
Metal Grease Filter
1.Remove screw from the grease filter retainer.
2.Turn the grease filter retainer to release filter.
A
A. Filter retainer
3.Wash metal filters as needed in dishwasher or hot detergent solution.
4.Reinstall the filter by placing the back edge in the channel at rear of hood. Push filter into place, turn the filter retainer to secure filter to range hood.
5.Replace screw in the grease filter retainer.
Replacing the Incandescent Light Bulb
Turn off the range hood and allow the light bulb to cool.
1.Disconnect power.
2.Squeeze the plastic lens cover and remove it from the hood.
A B
RANGE HOOD CARE
Cleaning
IMPORTANT: Clean the hood and grease filters frequently according to the following instructions. Replace grease filter before operating hood.
Exterior Surfaces:
IMPORTANT: Do not use
A. Light bulb socket
B. Lens cover
3.Screw light bulb into socket.
4.Replace lens cover by squeezing cover and inserting tabs into slots.
5.Reconnect power.
If new light does not operate, make sure the lamp is inserted correctly before calling service.
11