WARNING
Electrical Shock Hazard
Electrically ground blower.
Connect ground wire to green and yellow ground wire in terminal box.
Failure to do so can result in death or electrical shock.
8.Use
9.Replace terminal box cover.
10.Check all light bulbs to make sure they are secure in their sockets.
11.Reconnect power.
Complete Installation
1.Insert 3 screws on the bottom of the chimney structure (in corresponding position to the keyhole slots on the hood canopy).
A
A. Three screws
2.Lift hood canopy so that the large end of the keyhole slots are over the 3 screws on the bottom of the chimney structure.
3.Push the hood canopy so that the 3 screws are in the narrow end of the keyhole slots. Securely tighten the screws.
4.Install the remaining 9 screws and securely tighten.
Front
5.Connect lamp and control panels cable connectors to the blower motor connectors.
A
B
A. Control panel connection
B. Lamp connection
5. Reconnect power.
6. Check lights and blower operation. See “Use and Care Guide” section.
If hood does not operate:
■ Check that the circuit breaker is not tripped or house fuse blown.
■ Disconnect power. Check that wiring is correct.
7. For
Install Vent Covers
1.Insert captive nuts on the inside of the vent covers at all 14 rectangular hole locations.
2.Place the upper vent covers around the chimney structure so that the vent slots on the front cover face the same direction as the control panel.
A
A
A. Upper vent covers
9