5.Close the broiler door.
6.Remove cooktop burner caps and grates from parts package. Align notches in burner caps with pins in burner base. Burner caps should be level when properly positioned. If burner caps are not properly positioned, surface burners will not light. Place burners, burner caps and grates on the cooktop.
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death, fire, or electrical shock.
7.Plug into a grounded 3 prong outlet.
Verify Anti-Tip Bracket Location
1.Check that the
■Look for the
■Slide the range back so the rear range foot is under the anti- tip bracket.
Level Range
1.Place rack in oven.
2.Place level on rack and check levelness of range, first side to side; then front to back.
3.If range is not level, pull range forward until rear leveling leg is removed from the
4.Push range back into position.
5.Check that rear leveling leg is engaged in
NOTE: Range must be level for satisfactory baking performance.
Electronic Ignition System
Initial lighting and gas flame adjustments
Cooktop and oven burners use electronic igniters in place of standing pilots. When the cooktop control knob is turned to the “LITE” position, the system creates a spark to light the burner. This sparking continues until the control knob is turned to the desired setting.
When the oven control is turned to the desired setting, a hot surface igniter heats to a bright orange and ignites the gas. No sparking occurs. The glow bar remains on while the burner operates.
Check Operation of Cooktop Burners
1.If control panel and knobs were removed earlier, reinstall knobs.
2.Push in and turn each surface unit control knob to the “LITE” position. The flame should light within 4 seconds.
OFF
LITE
LO
HI
MED
3.Turn control knob to the “HI” position after burner lights.
4.Check each cooktop burner for proper flame. The small inner cone should have a very distinct blue flame ¼" (0.64 cm) to ½" (0.13 cm) long. The outer cone is not as distinct as the inner cone.
A
B
A. Outer cone
B. Inner cone
5.Turn the control knob quickly to the “LO” position after the burner lights. If the flame goes out, turn the control knob to the “OFF” position.
6.Check each cooktop burner for proper low flame. The low flame should be a minimum, steady blue flame. The flame size should be ¼" to ³⁄₈" (0.64 cm to 0.95 cm) high.
If the low flame needs adjusting:
1.With the burner flame on, turn control knob to the “Lo” setting and remove control knob.
10
