Complete Conversion
1.Refer to the “Make Gas Connection” section for properly connecting the range to the gas supply.
2.Turn the manual shutoff valve in the gas supply line to the open position.
3.Refer to “Check Operation” in the “Electronic Ignition System” section for proper burner ignition, operation and burner flame adjustments.
IMPORTANT: You may have to adjust the “LO” setting for each cooktop burner.
Checking for proper cooktop and oven burner flames is very important. The small inner cone should have a very distinct blue flame ¼" to ½" (0.64 cm to 0.13 cm) long. The outer cone is not as distinct as the inner cone. LP gas flames have a slightly yellow tip.
4.Close the oven door and turn the knob to “OFF.”
5.Refer to the “Complete Installation” section to complete this procedure.
Natural Gas Conversion
WARNING
Tip Over Hazard
A child or adult can tip the range and be killed.
Connect
Reconnect the
Failure to follow these instructions can result in death or serious burns to children and adults.
To Convert Gas Pressure Regulator
1.Turn manual shutoff valve to the “closed” position.
B
A
C
A. To range
B. Manual shutoff valve “closed” position
C. Gas supply line
2.Unplug range or disconnect power.
3.Open broiler door and remove broiler pan. The gas pressure regulator is located in the back right hand corner of the broiler compartment.
A
A. Gas pressure regulator
IMPORTANT: Do not remove the gas pressure regulator.
4.Remove the cap from the gas pressure regulator using a
NOTE: Do not remove the spring beneath the cap.
A
A.Cap
5.Turn the cap over so that N or NAT is visible.
A
A. Cap
6.Reinstall the cap.
14
