Whirlpool W100329708 installation instructions Remove template from floor and move to Step

If cabinet opening is wider than that specified in the “Location Requirements” section, adjust template so range will be centered in cabinet opening.

5.To mount anti-tip bracket to wood floor, drill two ¹⁄₈" (0.32 cm) holes at the positions marked on the bracket template.

Remove template from floor and move to Step 7.

To mount the anti-tip bracket to a concrete or ceramic floor, use a ³⁄₁₆" (0.5 cm) masonry drill bit to drill 2 holes at the positions marked on the bracket template. Remove the template from the floor. Tap plastic anchors into holes with a hammer.

6.Align the anti-tip bracket holes with the holes in the floor. Fasten the anti-tip bracket with the screws provided.

Depending on the thickness of your flooring, longer screws may be necessary to anchor the bracket to the subfloor. Longer screws are available from your local hardware store.

7.Move range close enough to the opening to allow for final electrical connection. Remove shipping base, cardboard or hardboard from under range.

8.Open the broiler door. Use a ³⁄₈" drive ratchet to lower the rear leveling legs one-half turn. Use a wrench or pliers to lower the front leveling legs one-half turn.

B

A

A. Rear leveling leg

A. Rear leveling leg

B. Front leveling leg

9.Adjust the leveling legs to the correct height. Leveling legs can be loosened to add up to a maximum of 1" (2.5 cm). A minimum of ³⁄₁₆" (0.5 cm) is needed to engage the anti-tip bracket.

10.Move range into its final location making sure rear leveling leg slides into anti-tip bracket.

11.If installing the range in a mobile home, you must secure the range to the floor. Any method of securing the range is adequate as long as it conforms to the standards in the “Location Requirements” section.

12.Continue installing your range using the following installation instructions.

8