5
2. Firmly grasp the power cord and pull to completely remove
the power cord, cord restraint, and pin from the rear panel.
3. Confirm that the power cord restraint (A), and pin (B) are
removed.
4. To remove the power cord from the cord restraint, push the
power cord in, press TAB, and then pull the power cord out.
Looped power cord
1. Firmly grasp the yellow shipping strap and pull until both ends
are completely removed from washer.
2. Check that two (2) cotter pins were removed with the shipping
strap.
Connect Drain Hose
Proper connection of the drain hose protects your floors from
damage due to water leakage. Read and follow these instructions.
The drain hose is connected to your washer and is stored inside
the washer cabinet.
Remove drain hose from washer cabinet
Gently pull the corrugated drain hose out of the washer from the
top of the hose. Continue to pull the hose until the end emerges.
Do not force excess drain hose back into the rear of the washer.
Laundry tub drain or standpipe drain

Connecting the drain hose form to the corrugated

drain hose

1. Feed end of drain hose into one end of form. Place end of
drain hose form into the drain hose relief.
2. Bend the hose over the top of the form and feed into the
other end of the form.

If drain hose does not fit into standpipe or if placing over

the edge of a laundry tub:

■Place coupling on end of drain hose. Use a screwdriver to
install hose clamp.
A.Power cord restraint B.Pin
Looped power cord
A

B

A.Drain hose reliefs
A