Dispenser operation
■Did you follow the manufacturer’s directions when adding detergent and fabric softener to the dispensers? Measure detergent and fabric softener. Slowly pour into the dispensers. Wipe up all spills. Dilute fabric softener in the fabric softener dispenser.
■Did you put powdered or liquid
Add powdered or liquid
■Is the fabric softener dispenser clogged?
Clean the fabric softener dispenser. See “Washer Care” for details.
■Are the laundry additives in the correct dispenser compartment?
Add the correct amounts of detergent, fabric softener or liquid chlorine bleach to the correct compartments. Add powdered or liquid
■Is there water in the dispenser at the end of the cycle? A small amount of water will remain in the dispenser compartment. This is normal.
Washer odor
■Have you run the Clean Washer Cycle lately?
To freshen your washer and to avoid odors, see “Cleaning Your Washer.”
■Are you using HE detergent?
Use of
■Did you leave the door open after use?
This washer has a tight seal to avoid water leaks. To avoid odors leave the door open to allow the washer to dry between uses.
Door won't unlock
■Did all of the water drain out of the washer during the spin?
Select DRAIN/SPIN to remove any water remaining in the washer. The washer door will unlock at the end of the drain.
■Is the door locked and is the “Add a garment” light on? Press PAUSE/CANCEL once. The door will unlock.
WasherOperation
Washer won't run, fill, rinse or tumble; washer stops
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death, fire, or electrical shock.
■Is the power cord plugged into a grounded 3 prong outlet?
Plug power cord into a grounded 3 prong outlet.
■Are you using an extension cord? Do not use an extension cord.
■Has a household fuse blown, or has a circuit breaker tripped?
Replace the fuse, or reset the circuit breaker. If the problem continues, call an electrician.
■Are both the hot and cold water faucets turned on? Turn on the water.
■Is the water inlet hose kinked? Straighten the hoses.
■Are the water inlet valve screens clogged?
Turn off the water and remove inlet hoses from the washer. Remove any accumulated film or particles. Reinstall hoses, turn on water and check for leaks.
■Is the washer in a normal pause in the cycle?
The washer pauses for about 2 minutes during certain cycles. Allow the cycle to continue. Some cycles feature periods of tumbling and soak.
■Is the washer overloaded? Wash smaller loads.
■Is the washer door firmly shut?
The door must be closed during operation.
■Are the shipping bolts removed?
All four shipping bolts must be removed for proper operation of the washer.
■Has a cycle been selected, but START has not been selected and held for 1 second?
Press and hold START, for 1 second.
■Was the door open after completion of last cycle?
The door must be opened and closed again to start a new cycle.
22
