Whirlpool W10110368 Troubleshooting, StorageDrawer, To Replace, To Remove, Nothing will operate

Models: W10110368

1 44
Download 44 pages 57.66 Kb
Page 18
Image 18

3.Close the oven door as far as it will shut.

4.Lift the oven door while holding both sides.

Continue to push the oven door closed and pull it away from the oven door frame.

StorageDrawer

The storage drawer can be removed. Before removing, make sure drawer is cool and empty.

To Replace:

1.Insert both hanger arms into the door.

2.Open the oven door.

You should hear a “click” as the door is set into place.

3.Move the hinge levers back to the locked position. Check that the door is free to open and close. If it is not, repeat the removal and installation procedures.

To Remove:

1.Pull the storage drawer straight back past the drawer stop notch and the end of the side rails.

A B

A. Drawer stop notch

B. End of side rail

2.Lift up the back of the drawer and pull the drawer out.

To Replace:

1.Lift up the back of the drawer and place it inside the range in its fully forward position.

2.Lift up the front of the drawer to a level position.

3.Slowly push the drawer into the range until the drawer side rails engage with the gap in the drawer glides.

A

A. Engage drawer glide.

4.Once the drawer is fully engaged on both sides, slide the drawer back into the closed position.

NOTE: When you are removing and replacing the storage drawer, a slight push may be needed to move the drawer stop notch past the drawer glides.

TROUBLESHOOTING

Try the solutions suggested here first in order to avoid the cost of an unnecessary service call.

Nothing will operate

Is the power supply cord unplugged? Plug into a grounded 3 prong outlet.

Household fuse blown or circuit breaker tripped? Replace the fuse or reset the circuit breaker. If the problem continues, call an electrician.

Is the main or regulator gas shutoff valve in the off position?

See Installation Instructions.

Is the range properly connected to the gas supply? Contact a trained repair specialist or see Installation Instructions.

Surface burners will not operate

Is the “Cooktop Lockout” set? See “Cooktop Lockout” section.

Is the oven in self-clean?

Surface burners will not operate during self-clean cycle.

Is a delayed self-clean set?

Surface burners will not operate until the self-clean cycle is complete.

Is the control knob set correctly? Push in knob before turning to a setting.

18

Page 18
Image 18
Whirlpool W10110368 manual Troubleshooting, StorageDrawer, To Replace, To Remove, Nothing will operate