Whirlpool W10115226B, W10115227B-SP

8

Put power supply cord through the strain relief. Be sure that

the wire insulation on the power supply cord is inside the

strain relief. The strain relief should have a tight t with the

dryer cabinet and be in a horizontal position. Do not further

tighten strain relief screws at this point.

Attach power supply cord

to strain relief

2.

A

B

C

D

Attach power supply cord

strain relief

Remove the screws from a 3/4" (19 mm) UL listed strain relief

(UL marking on strain relief). Put the tabs of the two clamp

sections (C) into the hole below the terminal block opening

(B) so that one tab is pointing up (A) and the other is pointing

down (D), and hold in place. Tighten strain relief screws just

enough to hold the two clamp sections (C) together.

1.

Power supply cord strain relief 4-wire Power Supply Cord Connection

Remove center terminal block screw (B). Remove neutral

ground wire (E) from external ground conductor screw (A).

A

E

B

Prepare to connect neutral

ground wire and neutral wire

1.

B

C

E

Connect neutral ground wire

and neutral wire

2.

Connect neutral ground wire (E) and neutral wire (white or

center) (C) of power supply cord under center terminal block

screw (B). Tighten screw.

IMPORTANT: A 4-wire connection is required for mobile

homes and where local codes do not permit the use of 3-wire

connections.

Power Supply Cord Connection

Power supply cord 4-wire receptacle

(NEMA Type 14-30R):

Go to “4-Wire Power Supply Cord

Connection” on this page.

Power supply cord 3-wire receptacle

(NEMA Type 10-30R):

Go to “3-Wire Power Supply Cord

Connection” on page 9.

If your outlet looks like this:

4-wire receptacle

(NEMA type 14-30R)

4-prong plug

Spade terminals with

upturned ends

Ring terminals

Contents

Main W10115226B W10115227B-SP ELECTRIC DRYER INSTALLATION INSTRUCTIONS 27" WIDE MODELS - U.S.A. ONLY Table of Contents Page INSTALLATION REQUIREMENTS Tools and Parts Tools needed: Parts needed: Location Requirements Electrical Requirements It is your responsibility: Electrical Connection If your outlet looks like this: INSTALL LEVELING LEGS Screw in leveling legs Prepare dryer for leveling legs ELECTRICAL CONNECTION Electrical Connection Options 1. NOTE: 2. A strain relief Power supply cord strain relief 4-wire Power Supply Cord Connection E 3. Connect remaining wires 2. 1. 3. 4-wire Direct Wire Connection IMPORTANT: A 4-wire connection is required for mobile relief B 2. ground wire and neutral wire E 1. 2. Direct wire strain relief 1. direct connection Direct Wire Connection 2. 4. 5. 3. direct connection 1. ground wire and neutral wire Connect neutral ground wire 3. Connect external ground wire VENTING Recommended Styles: Plan Vent System Optional exhaust installations: Alternate installations for close clearances Venting Kits Install Vent System Install exhaust hood Connect vent to exhaust outlet Connect vent to exhaust hood Vent System Chart Level Dryer Move dryer to nal location Level Dryer Tighten and adjust leveling legs Complete Installation Checklist q DOOR REVERSAL Reverse Door Swing (Optional) Remove screws from hinges 3. Rotate outer door Page Page Remove and transfer plugs W10115226B W10115227B-SP 11. Remove door strike plug Rotate outer door 13. 10.