Washer or Dryer Is In Its Packaging
WARNING
Excessive Weight Hazard
Use two or more people to move washer or dryer. Failure to do so can result in back or other injury.
1.Position the packaged washer or dryer close to its final position. Cut the packaging as follows:
Washer: Cut plastic |
|
film along dotted |
|
cut line around the |
|
base. Do not |
|
remove the |
|
packaging. |
|
Dryer: Cut carton | A |
around top and |
|
down corners |
|
along dotted cut |
|
lines. Lay all four carton sides on
floor. Discard carton top and corner posts.
IMPORTANT: Leave carton bottom underneath dryer.
2.Lay washer or dryer on its back.
NOTE: When laying the washer on its back, hold the bottom cap down on the floor. Do not remove the plastic film, corner posts or top cap. These protect the floor and washer back.
When laying the dryer on its back, the floor and dryer back are protected by pieces of the carton.
INSTALLATION INSTRUCTIONS
2. Verify the 4 spacer pads | A |
are installed on the top of |
|
Installing the Pedestal | the pedestal. |
|
Follow these instructions to install the pedestalon a washer or dryer.
WARNING
Excessive Weight Hazard
Use two or more people to move and install pedestal. Failure to do so can result in back or other injury.
1. Open the pedestal drawer as far as possible and remove the contents. This package contains 4, #12 x 5⁄8" hex head sheet metal screws used in step 5 and divider pack.
A. Spacer pads
3. Using 1/4” nut driver,remove the
the drawer from the slides and set aside. Push the slides back
into the pedestal.
A
A. Drawer slide | B |
B. |
|
4
