HYDRAULIC INSTALLATION
Keep hands and body away from pressurized lines. Use paper or cardboard, not hands or other body parts to check for leaks. Wear safety goggles. Hydraulic fluid under pressure can easily penetrate skin and will cause serious injury or death.
Make sure that all operating and service person- nel know that if hydraulic fluid penetrates skin, it must be surgically removed as soon as possible by a doctor familiar with this form of injury or gangrene, serious injury, or death will result. CONTACT A PHY-
SICIAN IMMEDIATELY IF FLUID ENTERS SKIN OR EYES. DO NOT DELAY.
Make sure all hydraulic hoses, fittings, and valves are in good condition and not leaking before starting power unit or using equipment. Check and route hoses carefully to prevent damage. Hoses must not be twisted, bent sharply, kinked, frayed, pinched, or come into contact with any moving parts. Operate moveable components through full operational range to check clearances. Replace any damaged hoses immediately.
9261 PUMP KIT INSTALLATION
Install Pump Kit
NOTE: For complete information on pump kit installa- tion, consult the Woods BH6500/7500 backhoe oper- ators manual.
1.Attach pump mounting bracket (2) to pump assembly with the offset toward the pump as shown in Figure 6.
2.Secure with cap screw (5) and lock nut (3) as shown.
3.Torque hardware to 85
NOTE: The pump mounting bracket is designed to slip over the tractor drawbar and prevent the pump from rotating. Trim the bracket flush with the bottom of the tractor drawbar if desired.
1.37909 Pump
2.31234 Pump mounting bracket
3.765 1/2 NC Hex lock nut
4.
5.3379 1/2 NC x
6.
Remove
Excess
BD3260
Figure 6. Pump Bracket Installation
8 Installation | MAN0131 (Rev. 12/23/2005) |
|
|
