4.If your washer or dryer has feet installed, remove them. Do
5.not install the feet that came with a new washer or dryer. Partially install 2 of the #12 x 5⁄8" hex head sheet metal screws in the lower holes. Leave a space of about 3⁄8" (1 cm) between the screw head and the bottom of the washer or dryer.
AB
C | C |
| A. Washer bottom |
| B. Dryer bottom |
6. Tip the pedestal on | C. Install screws |
| |
its back and move it |
|
against the washer |
|
or dryer bottom. |
|
Slide the pedestal’s |
|
keyhole slots over |
|
the lower 2 partially |
|
7.installed screws. Position the
pedestal toward the front of the washer
or dryer and install the 2 remaining hex- head sheet metal screws. Do not
8. tighten completely. Align the sides of
the pedestal so that they are even with the sides of the washer or dryer. Reach inside the pedestal drawer opening
9.and securely tighten all 4 pedestal screws.
Tip the washer or dryer back to its upright position. Remove and discard packaging including washer’s plastic film, corner
10.posts and top cap.
11.Slide the washer or dryer close to its final location.
Follow the Installation Instructions that came with your model to finish installing or reinstalling your washer or dryer (hoses,
12.vents, etc.).
LevelNOTE:the washer or dryer from side to side and front to back. Make sure all 4 pedestal feet are in solid contact with
the floor.
Place a level on the top. Locate the 1⁄4"
use a 1⁄4"
13.When the washer or dryer is level, use a 9⁄16"
against the pedestal. The locknuts must be tightened to prevent vibration. Recheck that the washer
or dryer is level. The washer or
dryer should not move front to back, side to side, or
14. diagonally when pushed on its top edges.
Pull both drawer slides out and reassemble the drawer to the drawer slides with the 2
NOTE:15. Use of the divider is optional. Remove the divider from
the bag.
16. Place the divider in the drawer at the desired location.
17. Close the drawer.
5
