Whirlpool W10325493A installation instructions Make Gas Connection

9.Open the broiler door. Use a ³⁄₈" drive ratchet to lower the rear leveling legs one-half turn. Use a wrench or pliers to lower the front leveling lets one-half turn.

B

A

A. Rear leveling leg

BFront leveling leg

A.Rear leveling leg

B.Front leveling leg

10.Adjust the leveling legs to the correct height. Leveling legs can be loosened to add up to a maximum of 1" (2.5 cm). A minimum of ³⁄₁₆" (0.48 cm) is needed to engage the anti-tip bracket.

11.Move range into its final location making sure rear leveling leg slides into anti-tip bracket.

12.If installing the range in a mobile home, you must secure the range to the floor. Any method of securing the range is adequate as long as it conforms to the standards in the “Location Requirements” section.

13.Continue installing your range using the following installation instructions.

Make Gas Connection

WARNING

Explosion Hazard

Use a new CSA International approved gas supply line.

Install a shut-off valve.

Securely tighten all gas connections.

If connected to LP, have a qualified person make sure gas pressure does not exceed 14" (36 cm) water column.

Examples of a qualified person include:

licensed heating personnel,

authorized gas company personnel, and authorized service personnel.

Failure to do so can result in death, explosion, or fire.

1.Remove grates.

2.Lift the cooktop by both front corners until the side support rods snap into place.

3.Locate gas pressure regulator inside the burner box.

A

A. Gas pressure regulator

IMPORTANT: Do not remove the gas pressure regulator.

4.All connections should go over and through the burner box and follow down the range back.

7