WHAT’S NEW UNDER THE LID?
Your new washer will operate differently than your past
Lid Lock
To allow for higher spin speeds, the lid will lock and the Lid Locked light will turn on. When this light is lit, the lid is locked and cannot be opened. When this light is blinking, the washer is paused. When this light is off, the lid can be opened. After a cycle is started, water will enter washer briefly, pause, and then lock. If you need to open the lid to add a garment after this point, you must press START/Pause/Unlock and wait for the lid to unlock. The lid will only unlock after washer movement has stopped. Depending
on when in the cycle you try to pause, it may take several seconds to several minutes for the lid to unlock. Press START/Pause/Unlock to resume the cycle.
Sounds
At different stages of the wash cycle, you may hear sounds and pauses that are different from those of your previous washer. For example, you may hear a clicking and hum at the beginning of the cycle as the lid lock goes through a
Sensing
This washer will perform a series of spins to check for load balance. During this time, a series of clicks and a whirring noise signal that sensing technology is determining if there is an
IMPORTANT:
• Washer will not operate if the lid is open.
Spray Rinse
Select cycles default to a spray rinse. During these cycles, you will hear water enter the washer as the tub spins, allowing the rinse water to penetrate clothes. Check the “Cycle Guide” for details.
•Water will enter washer briefly, pause, and then lock before sensing process begins. The sensing process may take
•Fabric Softener Added option must be selected “Yes” to ensure fabric softener dispenses at the correct time.
3
