Whirlpool WU565OV, WU3000V, WU4406V Proper Loading, To add a dish after starting, Top rack loading

To add a dish after starting

1.To be sure the added item is washed and rinsed, make sure the Cycle Control Knob has not passed LIGHT WASH on models WU3OOOV,WU3006V, WU44OOV, and WU4406V or ENERGY SAVER WASH on models WU565OV and WU685OV.

2.Lift up on the door latch to unlatch door and stop the cycle. Don’t open the door until the spray arms stop spinning.

3.Open the door and add the dish.

4.Close the door. Do not latch it. Wait 30 seconds for air in the dishwasher to warm up. This helps reduce the amount of moisture that can come from the vent when restarting the cycle.

5.Press the door to latch it. The dishwasher will start from where it stopped.

Changing a setting

You can change a setting anytime during any cycle.

1.Lift up on the door latch to unlatch the door and stop the cycle.

2.Turn the Cycle Control Knob clockwise to the cycle you want.

3.Be sure the deteruent disoensers are filled proper lydfor the new cycle.

4.Press door firmly to latch it. The dishwasher will automatically start the new cycle.

Proper Loading

Preparation for loading

It is not necessary to rinse dishes before putting them into the dishwasher. Just remove large pieces and quantities of food and bones. The filtering system helps keep food particles out of the wash water. Small particles are flushed away as water is pumped out. Larger particles are trapped on the filter screen system. Refer to “Dishwasher care and cleaning” on page 8 for filter screen cleaning instructions.

Always load dishes so soiled surfaces are reached by spray from rotating spray arms. Water must be able to drain off completely for best drying results. Be careful to separate items so spray can reach all surfaces

Top rack loading

The top rack is designed for cups, glasses and smaller items.

Cup and glass load

1 Place so open ends face down for cleaning and draining.

1 Load glassesin top rack only.

Bottom rack is not designed for glasses. Damage may occur.

. Place items in the rows between prongs. Placing them over the prongs can lead to breakage.

. Be sure lightweight items are held firmly in place.

1 China, crystal and other delicate items must not touch each other during dishwasher operation.

Damage may occur.

Page 6

Mixed load

. Load plastic items only in the top

rack. Only plastic items marked “Dishwasher Safe” are recom- mended. Plastic items can melt in the bottom rack.

. Load plastic items so the force of the spray does not move them during the cycle.

Utensil load

lSmall bowls, pans and other utensils can be placed in the top rack.

Bottom rack loading

Items with cooked-on or dried-on food should be loaded in the bottom rack with soiled surfaces facing inward to the spray.

Mixed load

. Make sure pot handles and other items do not stop rotation of either the upper or lower spray arm. Spray arms must move freely.

. Load items so they do not block or cover the spray tower.

. Securely place heavily soiled cookware face down in rack.

Dish load

. Place plates, soup bowls, etc., between prongs and facing the spray.

. Do not place items directly over spray tower.

Utensil load

. Load cookie sheets, cake pans and other items at sides or back. Loading items in front may keep water spray from reaching detergent dispenser.

NOTE:

1 Do not load glasses, cups or plastic items in the bottom rack.

1 When lower rack is removed, replace with bumpers in front.

Silverware basket loading

Load the silverware basket while in or out of the bottom rack. The loaded basket should be in the center front of the bottom rack.

Load forks and spoons so they don’t nest together. Spray can not reach

nested items. _

Mix items in each section of the basket with some pointing up and some down. Small items-baby bottle caps, jar lids, etc.-can be put in any section.

Personal Injury Hazard To avoid cuts from sharp items (knives, forks, skewers, etc.), make sure these items are put in point down.

Make sure sharp items (knives, forks, skewers, etc.) are put in point down. Make sure long items do not stop the upper spray arm from spinning.