Common Dishwashing
PROBLEM
Spotting and filming
Small particles deposited on items
Problems
CAUSED BY
Hard water
Water is not hot enough
Not enough detergent, or improper detergent
“Old” detergent
Improper loading
No rinse aid
Drying with Energy Saver Dry option
Spray arm or arms not rotating freely
SOLUTION
Fill detergent dispensers to capacity. Use dishwasher detergent with highest available phosphorous content. May be necessary to install water softener.
To remove spots and film, try a vinegar rinse..
1.Wash and rinse load as usual. Use Air Dry Option.
2.Remove all metal items.
3.Put 2 cups (500 mL) white vinegar in a container on the bottom rack.
4.Run dishwasher through a complete washing cycle.
Water temperature should be at least 140°F (60°C). Set water heater thermostat to a higher setting. Run water at sink until hot before starting, and/or use
Use more dishwasher detergent. Use detergent with highest available phosphorous content...especially with hard water.
Use only fresh dishwasher detergent. Store tightly closed container in cool, dry place. Discard old detergent. Do not fill dispensers until ready to start dishwasher.
Make sure dishes and glassware are loaded so spray reaches all surfaces and items drain properly. Do not overload. Do not nest items.
Make sure large items do not block spray from reaching detergent dispensers.
Is a new solid rinse aid needed or does the rinse aid dispenser need filling? See instructions on page 7.
Drying without heat may result in some spotting of glasses and silver.
Check spray arms to make sure they turn freely after loading. Be sure a utensil has not prevented their turning.
Continued on next page
Page