Whirlwind WW60-10001 Lubrication Information, Lubrication Fitting Location, Description Frequency

MAINTENANCE

MAINTENANCE

Before operating your Finishing Mower, make sure it is properly lubricated and thoroughy inspected. Only a minimum of time and effort is required to regularly lubricate and maintain this machine to provide long life and trouble free operation.

WARNING! Always disengage the PTO before raising the Rotary Cutter for transporting or making adjustments.

LUBRICATION INFORMATION

Do not let excess grease collect on or around parts, particulary when operating in sandy areas. The illustrations below shows lubrication points. The chart gives the frequency of lubrication in hours, based on normal operating conditions. Severe or unusual conditions may require more frequent lubrication. Figure 1.

Use an SAE multi-purpose, lithium-type grease for all locations shown. Be sure to clean the fitting thoroughly before using grease gun. Failure to maintain proper lubrication will result in damage to U-joints, gearbox, and/or driveshaft.

3
4
1
	5	3
5
2
	3
	LUBRICATION FITTING LOCATION FIGURE1
ITEM	DESCRIPTION	FREQUENCY
1	Gauge Wheel Pivots	8 Hours or daily
2	Wheel Hubs	8 Hours or daily
3	Blade Spindle	8 Hours or daily
4	U-Joint Telescoping Member	8 Hours or daily
5	U-Joints	8 Hoursor daily
WHIRLWIND 08/01	Maintenance Section 5-2
© 2004 Alamo Group Inc.