5
Adjusting
Your Lawn
Tractor
WARNING
Never attempt to make any adjustments while the engine
is running, except where specified in the operator’s manual.
Never attempt to adjust the brakes while the engine is running. Always disengage PTO, move shift lever into neutral position, stop engine and remove key to prevent unintended starting.
,OOSEN | 4IGHTEN |
TO LOWER DECK | TO RAISE DECK |
Figure |
|
!DJUSTMENT 'EAR (EXE"OLT
Figure
WARNING: Never attempt to make any adjustments while the engine is running, except where specified in the operator’s manual.
Leveling the Deck
NOTE: Check the tractor’s tire pressure before perform- ing any deck leveling adjustments. Refer to Tires on page 24 for information regarding tire pressure.
Front To Rear
The front of the cutting deck is supported by a stabilizer bar that can adjusted to level the deck from front to rear. The front of the deck should be between
1.With the tractor parked on a firm, level surface, place the deck lift lever in the top notch (highest position) and rotate the blade nearest the discharge chute so that it is parallel with the tractor.
2.Measure the distance from the front of the blade tip to the ground and the rear of the blade tip to the ground. The first measurement taken should be between 1/4” and 3/8” less than the second measurement. Deter- mine the approximate distance necessary for proper adjustment and proceed, if necessary, to the next step.
3.From the front of the tractor, loosen the hex lock nut on each end of the deck hanger rod, and turn away from the inner hex nuts. See Fig.
4.Tighten the inner hex nuts front against the front hanger bracket to raise the front of the deck; loosen the hex nuts to lower the front of the deck.
NOTE: Models with a
5.Retighten the two lock nuts against the inner hex nuts when proper adjustment is achieved.
Side to Side
If the cutting deck appears to be mowing unevenly, a side to side adjustment can be performed. Adjust if necessary as follows:
1.With the tractor parked on a firm, level surface, place the deck lift lever in the top notch (highest position) and rotate both blades so that they are perpendicular with the tractor.
2.Measure the distance from the outside of the left blade tip to the ground and the distance from the outside of the right blade tip to the ground. Both measurements taken should be equal. If they’re not, proceed to the next step.
3.Loosen, but do NOT remove, the hex cap bolt on the left deck hanger bracket. See Fig.
4.Balance the deck by using a wrench to turn the adjustment gear (found immediately behind the hex cap bolt just loosened) clockwise/up or counterclock- wise/down. The deck is properly balanced when both blade tip measurements taken earlier are equal.
5.Retighten the hex cap bolt on the left deck hanger bracket when proper adjustment is achieved.
Parking Brake Adjustment
WARNING: Never attempt to adjust the brakes while the engine is run- ning. Always disengage PTO, move shift lever into neutral position, stop engine and remove key to prevent unintended starting.
20
