Using your thermostat
Home, Sleep and Away Temperature Pre-Sets
You can set your (Home, Sleep, Away) temperatures for use when you get home, go to sleep, or leave home. Then, just press the button you want and go.
Favorite Temperatures are set at the factory as indicated in the following table. You can use
Factory
| HEATING | COOLING |
|
|
|
| 70o F | 75o F |
|
|
|
SLEEP | 62o F | 78o F |
|
|
|
| 62o F | 83o F |
|
|
|
| Your | |
|
|
|
| HEATING | COOLING |
|
|
|
|
|
|
SLEEP |
|
|
|
|
|
|
|
|
Change Home, Sleep and Away
Temperature Pre-sets
1.Move SYSTEM switch to HEAT position.
2.Using the 
or 
button, set the desired temperature.
3.Press and hold the Home, Sleep, or Away button for 3 seconds. The display will go blank (except for the battery icon and heat/cool icon) and back on again indicating that the thermostat has saved your
4.Repeat the process for the remaining
5.Move SYSTEM switch to COOL to
Use Home, Sleep and Away Temperature Pre-Sets
1.Press the Home, Sleep, or Away button. The display will show the icon for the button pressed and display the temperature setting.
2.The thermostat will maintain the selected
temperature until you change it by pressing the 
or 
button or selecting another
Sleep Timer Option
The sleep timer will automatically change the thermostat from the Sleep to Home temperature after the number of hours set in the configuration menu. The Sleep timer default is 8 hours and can be changed to a setting between 1 to 12 hours.
Example: You have selected 8 hours for the Sleep timer in the configuration menu. Press the Sleep button, the thermostat will maintain the sleep temperature for 8 hours. After 8 hours the thermostat will go back to the Home temperature. The Sleep timer will be activated each time the sleep button is pressed.
Change Filter Reminder Option
The thermostat can display a reminder when it is time to change the air filter on your heating and cooling system. The Change Filter will automatically display after the number of hours set in the configuration menu. The change filter reminder time default is 200 hours and can be changed to a setting of 25 to 1975 hours; 200 hours is approximately 3 months.
Example: You have selected 250 hours for the change filter reminder. The thermostat will display change filter after 250 it has
counted down 250 hours. When “Change Filter” is displayed, press the 
or 
button to clear the display and restart the timer.
Cool Savings™ Option
With Cool Savings enabled, the thermostat will make small adjustments to the desired temperature during periods of high demand to reduce cooling system running time and save energy. When the cooling system has been running for more than 20 minutes, humidity in the home will be lower and a higher temperature will feel comfortable. After 20 minutes of run time, the thermostat will start increasing the desired temperature in steps of less than one degree as the system continues to run. These adjustments will eventually cause the system to satisfy the thermostat and turn the system off to reduce the energy consumption. When the Cool Savings feature is active and making adjustments, the display will flash “Save”. The amount of adjustments to the desired temperature is dependent on the Cool Savings value that is set, 1 being the least adjustment and 6 being the most adjustment. With this feature set to OFF, no change will occur when the cooling system is continuously running during the periods of high demand. Periods of high demand will normally occur during the late afternoon and early evening on the hottest days of the summer.
3
