White Rodgers P200 installation instructions Select options

3.3 Select options

Press the PRGM and RUN buttons simultaneously.

You will be prompted to answer 8 “Options” questions, shown below.

As each option is presented:

✔Use the buttons to answer each question.

✔Use HOLD button to advance to the next question

and the TIME button to return to the previous question.

		Previous	Next
Options	Default Setting	Additional Information
1. Set the temporary	0:00	Select desired time, in
Hold Time (HOLD)		15-minute increments, for
		the duration of a temporary
		override of the current
		temperature. If you are not
		sure what to chose, 2 hour
		setting is usually a good
		starting point.
2. Do you want the	FA	Select SL (slow) if you have
Cycle Rate to be	(fast)	Hydronic (water or steam)
Fast or Slow?		heating. Otherwise, select
		default FA.
3. Do you want the	ON	Use default ON to
display light on		enable backlight
(d-L) for a short
time after any key
is pressed?

Options	Default Setting	Additional Information
4. Do you want	ON	Select default ON.
the Energy	(enabled)	Ensures the desired
Management		temperature is reached by
Recovery (E)		the designated program
function to be		schedule time
enabled?
5. Do you want	000	Select default 000 for now.
to be reminded	(no reminder)	To set a filter-change
when it is time to		reminder, see section 4.4
change the
air filter? (FLTR)
6. Compressor	OFF	Select ON to provide
Lockout (LOC)		protection to your Heating
		and Cooling System’s
		compressor
7. How much	0HI (no offset)	Select default 0HI for now.
displayed		To adjust the actual
temperature offset		temperature reading, see
do you want?		section 4.6
8. Do you want	°F
temperature	(Fahrenheit)
displayed in °C
(Celsius) or °F
(Fahrenheit)?

When you have answered all 8 questions, press the RUN button.

14 15