White Rodgers P200 Part 1 Before Getting Started, Check package contents, Assemble tools

Part 1 Before Getting Started

Before getting started, please review the following pre-installation checklist.

1.1 Check package contents

1.2Answer questions about source of heating in your home

✔Do you have either oil or gas burning furnace?

✔Do you have Hydronic Heating (steam or hot water radiators or radiant floor heating)?

Open the package and verify that the following items are included:

•Thermostat wallplate (A) and cover (B)

•2 mounting screws and wall anchors (C)

•Wire Labels

•Installation Instructions and User Guide

1.3 Assemble tools

You will need the following tools:

✔Flat-head screwdriver

✔2 AA alkaline batteries

You may also need:

✔Hammer

✔Drill with 3/16" (4 mm) bit

✔Small pliers to bend wires

A

B

C

If any of the items shown above are missing from your package, call White-Rodgers™customer service at 1-877-654-9394 before returning the thermostat to your place of purchase.

1.4Turn off power to your heating and cooling system

Typically, this is achieved by flipping a switch on the outside of the furnace/air handler to the “OFF” position.

Do not turn the system back on until you have completed the installation and set up of the thermostat.

2 3