White Rodgers UP400 Part 1 Before Getting Started, Check package contents, Assemble tools

Part 1 Before Getting Started

Before getting started, please review the following pre-installation checklist.

1.1 Check package contents

Open the package and verify that the following items are included:

• Wallplate (A) thermostat (B) white cover (C)
•	4 color inserts (D)
•	Clear plastic cover (E)

1.2Answer questions about source of heating in your home

✔Do you have either an oil or gas burning furnace?

✔Do you have a Heat Pump (and is it 1-stage or 2-stage)?*

✔Do you have Hydronic Heating (steam or hot water radiators or radiant floor heating)?

*To determine if you have a Heat Pump and/or whether it is a 1-stage or 2-stage model, see the Appendix on the last page of the Manual.

• 2 mounting screws and wall anchors (F)

• Wire Labels

• Installation Instructions and User Guide

A

B F

C

1.3 Assemble tools

You will need the following tools:

✔Flat-head screwdriver

✔2 AA alkaline batteries

You may also need:

✔Hammer

✔Drill with 3/16" (4 mm) bit

✔Small pliers to bend wires

DE

If any of the items shown above are missing from your package, call White-Rodgers™customer service at 1-877-654-9394 before returning the thermostat to your place of purchase.

1.4Turn off power to your heating and cooling system

Typically, this is achieved by flipping a switch on the outside of the furnace/air handler to the “OFF” position.

Do not turn the system back on until you have completed the installation and set up of the thermostat.

2 3